"If it wasn't for Jimmy Chahalis, this car would be nowhere near what it is today," Mike s
Horse Sense: Many people have the windows of their Mustangs tinted, but Mike Mohring is not like most people. He says he's had countless people coming over to his car (probably right after getting their doors blown off), looking for nitrous nozzles or a bottle in the hatch. "That's one of the reasons I never tinted the windows," Mike says. "I have nothing to hide."
Yeah, Mike Mohring's '88 GT runs mid 10s all day long, but if you're looking to read about some exotic combination in this car, keep flippin' the pages. However, if you're hoping to find a simple combination for your 5.0 Mustang, look no further. You'll soon see it doesn't take some double-throw-down, off-the-top-rope, hot-out-of-the-R&D-department mixture of parts to go fast. What it will take is a phone call to a few 5.0&SF advertisers to come up with a powerful package-one the competition won't see coming.
What people see when they look at Mike's car is an extra-clean Fox GT. But it wasn't always that way. Mike bought the car in 1997 for $4,800 when he tired of dumping money into his '90 LX AOD. He figured it was time to move on, and the GT had what he wanted most-a five-speed. Oh, yeah-it also boasted a ball-drive Paxton supercharger. Mike, who hails from East Bruns-wick, New Jersey, raced the car just about every weekend-until he busted the stock T5.
Because he spent so much time racing, he wanted the car to be consistent. His buddy Bryan Cranston recommended he throw in a Performance Automatic C4 with a 10-inch converter. Much to the chagrin of stick proponents, Mike says the car picked up seven tenths the first time out by running a 12.18 compared to the usual 12.80s-12.90s. Mike professes he can't drive a stick car that well, but with the automatic he was able to get the car down to a best of an 11.95, still using the stock cam, the GT-40 iron heads, a stock intake, and the Paxton.
There's nothing fancy or earth-shattering interiorwise either. The most exotic components
"It finally blew a head gasket and I ended up at LaRocca's Performance," Mike says. LaRocca's Jimmy Chahalis recommended adding a new engine, better heads, and a Vortech S-Trim. "I agreed to the new engine with the better heads, but not the blower," Mike says. With the Paxton still in place, the GT received a new 306 with GT-40X heads, an Edelbrock Performer 5.0 intake, and 30-lb/hr injectors.
With that combo, the car ran a best of 11.56 at 116 mph, but Jimmy continued to push Mike about adding the Vortech. "I caved in," Mike says, "but I said it has to run 10.80s with it." Jimmy responded, "Not without some other work it won't-but it will." He said to expect 11.20s by just bolting on the Vortech. "So on went the S-Trim," Mike says, "and it made 76 more rear-wheel horsepower just by bolting it on." Literally just a few hours off LaRocca's dyno, Mike was at the track, where the car responded with an 11.30 and then an 11.20. "I was happy, to say the least," he says. "Mph was up to 122. But the 60-foot times sucked, so we turned to the suspension."
Mike added Factory 5 upper and lower control arms, Eibach springs, and new slicks. "The car came around and started going 10.80s without a problem," he says. Another couple years and roughly 250 passes later, the engine began to show signs of a meltdown, so the car's existing top-end compo-nents were added to a D.S.S. Pro Bullet 306 short-block. Jimmy did the parts swapping, while Mike's friend Scott Gary performed some bowl work on the X heads.
The next run to the track rewarded Mike with 10.60s, and a best of a 10.49 at 128 mph at the end of 2002. "It sat all winter," Mike says, "and all I did to prepare it for spring was an oil change and fresh gas." The car ran a 10.52 at 128 mph the first time out in 2003. "Not bad for not touching it," he says. Perhaps a reward for his hard work, Jimmy ran the car and belted out a 10.54 at 129 mph, beating Mike's mph but not the car's best time (then we'd really have to rib Mike).
"The car is a simple and reliable combo," Mike says. "The only thing touched is the heads-that's it-but in out-of-the-box form, the car ran 10.70s at 126 mph. Not bad for something you can buy out of a magazine and put together without any port and polish work to anything."
Mike says most people come over to the car; take a look, and then walk away seemingly unimpressed. That is, until they see the wheels come a foot off the ground at launch. Then they're back, looking for trick pieces or even nitrous nozzles and bottles. Needless to say, Mike loves to see their reactions when the car runs a mid-10-second pass with anyone-can-buy parts.
People are always looking for that over-the-top component that makes Mike's car this fast, but it's simply not there. They think the Vortech must have a small pulley on it. But Mike says, "Read it for yourself." The pulley is stamped with a 3.33-inch designation. "They think the car is your typical 13-second street car with a big hood and shiny wheels," he says, "The rollbar doesn't even bother them." What does bother them is the simple spanking they receive.